WARNING!
Danger due to misuse!
Misuse of the pneumatic agitator can lead to hazardous situations.
–
Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations applicable for the area of use for the
pneumatic agitator.
–
Only carry out the installation and commissioning according to the steps described in this
operating manual.
–
Only use the manufacturer's original spare parts.
–
Only operate the pneumatic agitator in compliance with the values specified in the (
Chapter 12 ‘Technical data’ on page 39
–
A pressure relieve screw has been placed on the side of the adapter plate of the com-
pressed-air motor. It must not be covered up under any circumstances and the exhaust
air must not be reduced.
–
Only operate pneumatic agitator in installed condition and in closed containers.
–
Only operate pneumatic agitator in vertical position with agitator impellers facing down.
–
Adhere to the spray media manufacturer's safety data sheets.
–
Never direct compressed air towards humans or animals.
–
Do not operate pneumatic agitator in areas that are at risk for explosions.
No claims of any type can be asserted due to damage resulting from misuse.
2.6 General safety instructions
Hoses and cables
CAUTION!
Risk of injury through tripping over hoses and cables!
Hoses and cables are slipping and tripping hazards. A fall can cause injuries.
–
Always pay attention to hoses and cables in the working environment.
–
If possible, run hoses and cables outside of the work area.
Pneumatic agitator RL 72
ENGLISH
Article no.
■
200-0356
GB–9
Содержание 200-0356
Страница 44: ......