CAUTION!
Risk of injury due to sharp edges!
Sharp edges and pointed corners can cause abrasions and cuts on the skin.
Note:
–
Proceed cautiously when working on or near sharp edges and pointed corners.
–
Wear protective gloves, if in doubt.
Hose and pipelines
Even with intended use by environmental influences, the service life of hose lines and pipe-
lines is limited. For the sake of prevention, all hose and pipelines should be replaced regularly
according to their load.
7.2 General maintenance information
The following sections describe the maintenance work that is required for optimal and fault-free
operation of the device.
Check wearing parts such as seals at regular intervals. The level of wear depends on the abrasive-
ness of the spray fluid used. Escaping air and spray fluid are signs that parts are worn. Contact
Krautzberger Customer Care with any questions on maintenance work and maintenance intervals.
7.3 Maintenance schedule
Interval
Maintenance work
Prior to each work process
Check the material or compressed air lines to make sure they
are undamaged and have a secure fit
Before performing any mainte-
nance work
Chapter 7.4 ‘Clean the diaphragm
)
Prior to every long-term shut-
down
As necessary
Chapter 7.4 ‘Clean the diaphragm
)
Replace valve parts (
Chapter 7.5 ‘Replace valve parts’
)
Replace diaphragms (
Chapter 7.6 ‘Replace the diaphragm’
)
Operating instructions
T-Dok-300-GB-Rev.1
[email protected], www.krautzberger.com
GB–28
