WARNING!
Hearing damage due to excessive noise exposure!
Depending on the operating conditions, the sound pressure of the device/machine may cause
hearing damage.
Note:
–
Take suitable action to reduce the impact of the existing sound pressure level. The owner
is responsible for the type and implementation of suitable measures, which may depend
on the local conditions.
6.2 General information about the start-up
Adhere to the following general information for the start-up:
n
Carry out the start-up of the diaphragm pump only in compliance to the steps described in
these operating instructions.
n
Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations for the area of use for the diaphragm pump.
n
Check the material and compressed air hose lines for damage and tight fit before each use.
n
The chemical resistance of the materials which we use cannot always be assessed with
authority due to the large number of fluids, concentrations, temperatures and impurities used.
For this reason, please test the suitability because we cannot extend any respective guaran-
tees.
n
Adhere to the spray media manufacturer's safety data sheets.
n
Only operate the diaphragm pump in compliance with the values specified in (
).
n
Only operate the diaphragm pump after fastening it properly to a suitable supporting structure.
n
Do not hold the diaphragm pump in your hand during operation.
n
It is recommended to flush the diaphragm pump prior to initial start-up using a suitable
cleaning agent.
n
Make sure that the connected compressed air is oil-free and free from solid matter.
6.3 Shutting down
6.3.1 Temporary shut-down
Interrupt the compressed air supply in a suitable location (e.g. shut-off device).
6.3.2 Long-term shut-down
1.
Interrupt the compressed air supply in a suitable location (e.g. shut-off device).
2.
Chapter 7.4 ‘Clean the diaphragm pump’ on page 29
3.
Interrupt the compressed air supply at a suitable location (e.g. shut-off device) and secure it
against a restart.
Diaphragm pump MP-560
ENGLISH
Article No. 200-0192
GB–25
