Kramer Electronics Ltd.
WP-20CT
– Defining WP-20CT Wall-Plate HDBaseT Auto Switcher/Transmitter
5
#
Feature
Function
USB-C IN Port
Connect to a USB-C source (that supports DisplayPort
Alternate Mode).
•
When powered by a Kramer 20V power supply (optional),
charges sources (that support USB Power Delivery 2.0)
up to 60W.
•
Use to access
WP-20CT
embedded web pages via
connected browser.
12V/20V Power Supply 2-pin
Terminal Block Connector
Connect to the power supply (required for USB charging).
Connect GND to GND, +12V/20V to +12/20V.
•
If you need to charge a device via the USB-C port, use
Kramer 20V power supply (optional).
HDBT OUT PoE
RJ-45
Connector
Connect to the HDBaseT IN port on a PoE-provider receiver
(for example,
TP-789R
) or a receiver (for example,
TP-580R
).
•
When
WP-20CT
is connected to a PoE providing receiver,
it is not necessary to connect a power supply, unless the
USB-C charging feature is used which requires the
Kramer 20V power supply.
CONTROL RS-232 3-pin
Terminal Block Connector (Tx,
Rx, and common G)
Connect to a controller to control the device.
EXTD RS-232 3-pin Terminal
Block Connector (Tx, Rx, and
common G)
Connect to a controller to extend an RS-232 bi-directional
signal (even if no A/V signal is extended).
AUDIO OUT 3-pin Terminal Block
Connector
Connect to an unbalanced analog audio acceptor.
Ring Tongue Terminal Grounding
Screw
Connect to grounding wire (optional).
4
5
6
7
8
9
10
