Kramer VS-88FO, Руководство пользователя

Страница: 18 / 45

VS-88FO - Connecting the VS-88FO 15
2. To set the genlock timing, press and hold for 3 seconds the appropriate input
button as follows:
To Set Press and Hold
for 3 Seconds
Setting
Displayed
1080i @60Hz IN 1 1080 60H
1080i/p @50Hz IN 2 1080 50H
720p @60Hz IN 3 720P 60H
PAL @50Hz IN 4 PAL 50H
NTSC @60Hz IN 5 NTSC 60H
Note : When turning the machine ON, the last stored setup is shown in the
7-segment display.
5.5 Connecting via Ethernet
You can connect to the VS-88FO via Ethernet using either of the following
methods:

Directly to the PC using a crossover cable (see Section
5.5.1
)

Via a network hub, switch, or router, using a straight-through cable (see
Section
5.5.2
)
Note : If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
5.5.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the VS-88FO directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the VS-88FO
with the factory configured default IP address.
After connecting the VS-88FO to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center .
2. Click Change Adapter Settings .
3. Highlight the network adapter you want to use to connect to the device and
click Change settings of this connection .
i