Using the Configuration Menus
19
19
8 Using the Configuration Menus
The configuration menus let you configure the
VS-3232DVI
to best suit your
needs. There are two configuration menus:
•
Setup Menu—those that are accessed on a regular basis (for example, storing
setups and setting the delay), see
•
Config Menu—those that are accessed only occasionally (for example, setting
the interface or communication protocol), see
Section 8.1
The following rules apply to the menu operation:
Section 8.2
•
If no selection is made within approximately 15 seconds, the operation times-
out and the display reverts to the output/input display
•
At any point in the Menu, press ESC to move up one level or press
BREAKAWAY to exit the Menu altogether
•
At any point in the Menu, only buttons that are active light or flash
•
All of the procedures in this section assume that you are starting the procedure
from the standard operational output/input display
8.1 Using the Setup Menu
The Setup Menu provides access to settings that are regularly changed and
comprises the following options:
•
1: inXX=>ALL
, switching one input to all outputs (see
Section 8.1.1
•
3: outXX=OFF
, turning off an output (see
)
Section 8.1.2
•
7: EDID
, assignment to an output (see
)
Section 8.1.3
•
9: Delay
setting for an output (see
)
Section 8.1.4
•
4: store setup XX
, storing the setup in a preset (see
)
Section 8.1.5
•
6: recall setup XX
, recalling a preset (see
)
Section 8.1.6
8.1.1 Setup Menu—1: inXX=>ALL, Switching one Input to all Outputs
)
This option switches one input to all outputs.
To switch one input to all outputs:
1. Press MENU.
The Setup Menu options are displayed.
2. Press 1 (ALL).
The following is displayed:
in__ => ALL
3. Using the numeric keys, enter the input to be switched to all outputs.
The TAKE button flashes.
4. Press TAKE.
The selected input is switched to all outputs.