VS-1616D - Using the Input / Output Cards
77
UHDA-IN2-F16 Input Card
Parameter
Description
Default
ST
Selects the manner in which the analog audio port functions.
0=Input. If an analog source is connected, the port acts as an input
and embeds the audio into the HDMI signal that goes to the matrix.
1=Output. The audio is de-embedded from the HDMI source and is
output as analog audio. (
Note
: The 3.5mm mini jack connector acts
as an output in this case!)
2=ARC. The audio is taken from the 3.5mm mini jack connector and
sent to the ARC device which is connected to the HDMI input.
0
HDCP
Turn HDCP on and off.
*0=EN, 1=DIS.
Note
: Analog audio is still transmitted when HDCP is disabled.
0
Reset Input
Re-power: power cycles the port.
Factory: performs a factory reset to default values of the port.
Re-power
The
UHDA-OUT2-F16
configuration table appears as follows:
UHDA-OUT2-F16 Output Card
Parameter
Description
Default
Volume
Sets the audio output volume (0–70).
50
Audio Balance
Sets the audio output channel balance (0–100).
50
Audio Bass
Sets the audio output bass level (0–15).
7
Audio Treble
Sets the audio output treble level (0–15).
7
Audio Mute
MUTE: mutes the audio output.
Non-MUTE: unmutes the audio output.
Note
: When set to Mute, any change to the audio parameters
automatically sets this to unmute.
Non-MUTE
Audio Mono
OFF—Analog output is stereo.
MIX—Analog output is mono.
OFF
ST
Selects the manner in which the analog audio port functions.
0=Input. If an analog source is connected, the 3.5mm mini jack
connector acts as an input and embeds the audio into the HDMI
output signal.
1=Output. The audio is de-embedded from the HDMI signal routed to
this card, and is output as analog audio with the 3.5mm mini jack
connector acting as an output.
2=ARC. The audio is taken from the sink that supports ARC and is
output as analog audio on the 3.5mm mini jack connector.
1
Switch Speed
When switching between different sources the switching time can be
reduced by setting the fast switch level (Fast Switch or
Normal Switch).
Normal
Switch
Reset Output
Re-power: power cycle the port.
Factory default: perform a factory reset of the port to default values.
Re-power
