VS-1616D - Using the Input / Output Cards
79
9.16.1
VGA-IN2-F16 / VGA-OUT2-F16 Configuration
The
VGA-IN2-F16
configuration table appears as follows:
VGA-IN2-F16 Input Card
Parameter
Description
Default
Resolution Detect
Auto, User Defined, Auto Adjust, (see note below table).
Auto
Phase Mode
Auto, User Defined, Auto Adjust, (see note below table).
Auto
Brightness
(0–63)
32
Contrast
(0–63)
32
Phase adjustment
(0–63)
Note
: This adjustment is only valid when Phase Mode Is set to User
Defined mode.
As detected
Reset Input
Re-power: power cycles the port.
Factory: performs a factory reset of the port to default values.
Re-power
Hor-Total Pixels
Set the value for total horizontal pictures.
(1–7000)
As detected
Horizontal-Start
Set the value for horizontal start.
(1–600)
As detected
Horizontal-Active
Set the value for horizontal active pixels.
(1–4000)
As detected
Vertical-Start
Set the value for vertical start.
(1–255)
As detected
Vertical-Active
Set the value for vertical active pixels.
(1–3000)
As detected
Save Timing Para
(0–31)
0
Recall Timing Para
(0–31)
0
R-offset
(0–63)
32
G-offset
(0–63)
32
B-offset
(0–63)
32
R-gain
(0–63)
32
G-gain
(0–63)
32
B-gain
(0–63)
32
The Auto Adjust feature requires the device to recalculate the
parameters based on the currently connected source. The result may
be different from the standard parameters for the currently set
resolution. The result is saved in non-volatile memory and is recalled
when the same source is used again. In order to revert to auto
predefined parameters, either reset to factory setting with the
relevant source connected or connect a different source.
The
VGA-OUT2-F16
configuration table appears as follows:
VGA-OUT2-F16 Output Card
Parameter
Description
Default
Switch Speed
When switching between different sources the switching time can be
reduced by setting the fast switch level (Ex-fast Switch, Fast Switch
or Normal Switch).
Normal
Switch
