Kramer VP-734, Руководство пользователя

Страница: 19 / 83

14 VP-734 - Connecting the VP-734
5.3 Connecting the Balanced/Unbalanced Stereo Audio
Output
Figure 5: Connecting the Balanced
Stereo Audio Output Figure 6: Connecting an Unbalanced Stereo
Audio Acceptor to the Balanced Output
5.4 Connecting the VP-734 via the ETHERNET Port
You can connect to the VP-734 via Ethernet using either of the following methods:

Directly to the PC using a crossover cable (see Section
5.4.1
)

Via a network hub, switch, or router, using a straight-through cable (see
Section
5.4.2
)
Note : If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
5.4.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the VP-734 directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the VP-734
with the factory configured default IP address.
After connecting the VP-734 to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center .
2. Click Change Adapter Settings .
3. Highlight the network adapter you want to use to connect to the device and
click Change settings of this connection .
The Local Area Connection Properties window for the selected network
adapter appears as shown in Figure 7 .