Your VP-4x8 4x8 VGA / UXGA Matrix Switcher
7
#
Feature
Function
20
ETHERNET
RJ-45 Connector
Connects to the PC or other Serial Controller through computer
networking
21 ETH Factory Reset Button
Press to reset to factory default definitions
1
:
IP number 192.168.1.39
Mask – 255.255.255.0
Gateway – 192.168.1.1
22
REMOTE IR
3.5mm Mini Jack
Connect to an external IR receiver unit for controlling the machine
via an IR remote controller (instead of using the front panel IR
receiver)
2
23
RS-485
Terminal Block Port
Pin G is for Ground connection; Pins B (-) and A (+) are for RS-
485
24 Power Connector with Fuse
AC connector enabling power supply to the unit
Figure 2
illustrates the underside of the
VP-4x8
unit, and
Table 3
defines
the underside features.
Figure 2: VP-4x8 Underside View
Table 3: VP-4x8 Underside Panel Features
Feature
Function
RESET FOR PROGRAM
Button
Press to reset unit prior to firmware upgrade
(see section 9.1.3)
1 First disconnect the power cord and then connect it again while pressing the ETH Factory Reset button. The unit will power
up and load its memory with the factory default definitions
2 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if the internal
IR connection cable has been installed)
