Kramer VP-4x4xl, Руководство пользователя

Страница: 9 / 39

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your UXGA / Audio Matrix Switcher
6
Table 2: Rear Panel VP-4x4xl 4x4 UXGA / Audio Matrix Switcher Features
# Feature Function
18 INPUT HD15F Connectors Connects to the VGA/XGA video sources (from 1 to 4)
19 AUDIO INPUTS Terminal
Block Connectors
Connects to the balanced stereo audio sources (from 1 to 4)
20 OUTPUT HD15F Connectors Connects to the VGA/XGA video acceptors (from 1 to 4)
21 AUDIO OUTPUTS Terminal
Block Connectors
Connects to the balanced stereo audio acceptors (from 1 to 4)
22 FLASH PROG. Button Push in for “Program” to upgrade to the latest Kramer firmware (see
section 8), or release for Normal (the factory default)
23 RS-485 Terminal Block Port Pins B (-) and A (+) are for RS-485; Pin G (Ground) may be connected to
the shield of the cable if desired (see the PINOUT in Figure 7)
24 RS-232 DB 9F Port Connects to the PC or the Remote Controller
25 REMOTE IR opening
1
Connects to an external IR receiver unit for controlling the machine via
an IR remote controller (instead of using the front panel IR receiver)
2
26 DELAY Dipswitches Dipswitches for setting the delay time
27 Setup Dipswitches Dipswitches for setup of the unit (DIP1, DIP 2 and DIP 3 are for setting
the machine #; DIP 4 is for RS-485 Termination)
28 Power Connector with Fuse AC connector enabling power supply to the unit
4.1 Using the IR Transmitter
You can use the
RC-IR2
IR transmitter to control the machine via the built-in
IR receiver on the front panel or, instead, via an optional external IR receiver
3
.
The external IR receiver can be located 15 meters away from the machine.
This distance can be extended to up to 60 meters when used with three
extension cables
4
.
Before using the external IR receiver, be sure to arrange for your Kramer
dealer to insert the internal IR connection cable
5
with the 3.5mm connector
that fits into the REMOTE IR opening on the rear panel.
Connect the external IR receiver to the REMOTE IR 3.5mm connector.
1 Covered by a cap. The 3.5mm connector at the end of the internal IR connection cable fits through this opening
2 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if the internal
IR connection cable has been installed)
3 Model: C-A35M/IRR-50
4 Model: C-A35M/A35F-50
5 P/N: 505-70434010-S