KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-4x4xl 4x4 UXGA / Audio Matrix Switcher
8
6 Connecting the VP-4x4xl 4x4 UXGA / Audio Matrix Switcher
This section describes how to:
Connect the
VP-4x4xl
rear panel (see section 6.1)
Connect a balanced stereo audio input/output (see section 6.2)
Connect the
VP-4x4xl
to a controlling device via RS-232 (see section 6.3)
Connect several
VP-4x4xl
machines (see section 6.4)
Set the dipswitches (see section 6.5)
6.1 Connecting the VP-4x4xl Rear Panel
To connect
1
the
VP-4x4xl
, as illustrated in the example in Figure 2, do the
following
2
:
1. Connect up to four VGA/XGA computer graphics sources to the HD15F
INPUT
connectors (from INPUT 1 to INPUT 4).
2. Connect up to four balanced
3
stereo audio sources (for example, the
audio source of the computer
4
) to the AUDIO INPUT terminal block
connectors (from 1 to 4).
3. Connect the four OUTPUT connectors to up to four VGA/XGA video
acceptors (for example, displays).
4. Connect the four AUDIO OUTPUT terminal block connectors to up to
four balanced stereo audio acceptors
3
(for example, balanced stereo
audio amplifiers with speakers).
5. Set the dipswitches (see section 6.5).
6. If required, set the switching delay time (see section 6.6)
7. As an option, you can connect a PC and/or controller to the RS-232 port
(see section 6.3) and the RS-485 port (see section 6.4).
8. Connect the power cord
5
.
1 You do not need to connect all inputs and outputs
2 Switch OFF the power on each device before connecting it to your VP-4x4xl. After connecting your VP-4x4xl, switch on its
power and then switch on the power on each device
3 See section 6.2
4 Alternatively, you can connect a separate audio source (as shown for input 1 in Figure 2), or no source at all
5 We recommend that you use only the power cord that is supplied with this machine
