Connecting the VP-26 Presentation Matrix Switcher
13
the projector
The VGA/UXGA UXGA OUT 15-pin HD (F) connector to the
VGA/UXGA input of the projector
The three OUT RCA connectors Y, P
B
/C
B
and P
R
/C
R
to the
component video input of the projector
3. Connect the appropriate balanced audio sources and acceptors (not shown in
Figure 4
1
).
4. Connect the MASTER OUTPUT LINE terminal block connector, if
required (not shown in
Figure 4
; see section
7.3
).
5. Connect the MASTER OUTPUT SPKR block connector to a pair of
loudspeakers, by connecting the left loudspeaker to the “L+” and the “L-”
terminal block connectors, and the right loudspeaker to the “R+” and the
“R-” terminal block connectors.
Do not Ground the loudspeakers
.
6. Connect the CAT 5 VGA 2 OUT twisted pair connector (see section
6.3
) to
a line receiver (for example, the
TP-122
XGA / Audio Line Receiver
2
,
which is connected to a remote display and speakers).
7. Connect a dynamic or a condenser microphone
3
, if required, to the MIC IN
XLR connector.
8. You can connect a PC and/or controller to the:
RS-232 port (see section
6.4
)
RS-485 port (see section
6.5
)
ETHERNET (see section
6.6
)
9. Connect the unit to additional machines (if required) via the RS-485 port
(see section
6.7
) for control.
10. Connect the power cord.
1 In
Figure 4
, the audio connections are not shown, except for the microphone and speakers connections
2 The receiver receives the CAT5 signal, decodes it and outputs it to a VGA acceptor
3 Use the Con/Dyn switch (refer to the rear panel, item 2 in
Figure 2
) to select a dynamic microphone or a condenser
