KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-26 Presentation Matrix Switcher
12
6
Connecting the VP-26 Presentation Matrix Switcher
This section describes how to:
•
Connect the rear panel (see section
6.1
)
•
Connect the audio (see section
6.2
)
•
Wire the CAT 5 connector (see section
6.3
)
•
Connect a PC or other controller via the RS-232 port (see section
6.4
)
•
Connect a controller via the RS-485 port (see section
6.5
)
•
Control via the ETHERNET (see section
6.6
)
•
Cascade several machines (see section
6.7
)
•
Set the DIP-switches (see section
6.8
)
6.1
Connecting the VP-26 Rear Panel
To connect
1
the
VP-26
, as the example
2
illustrated in
Figure 4
shows
3
, do
the following
4
:
1. Connect the following video sources, that is, one
5
:
VGA/UXGA source (for example, a computer graphics source)
to the VGA/UXGA IN 1 15-pin HD (F) connector
Composite video source (for example, a composite video
player) to the CV IN 1 BNC connector
s-Video source (for example, an s-Video player) to the Y/C IN
1 4-pin connector
Component video source (for example, a DVD player) to the
three IN 1 RCA connectors Y, Pb/Cb and Pr/Cr
2. Connect the OUT 1 acceptors to a projector
6
as follows:
The composite video CV OUT BNC connector to the
composite video input of the projector
The s-Video Y/C OUT 4-pin connector to the s-Video input of
1 You do not need to connect all the inputs
2 In this example, each of the OUT 1 connectors (one from each group) is connected to the same projector. Use the projector
controller to switch between the VP-26 video outputs (or projector inputs)
3
In Figure 4, the audio connections are not shown, except for the microphone and speakers connections
4 Switch OFF the power on each device before connecting it to your VP-26. After connecting your VP-26, switch on its
power and then switch on the power on each device. Switching on the VP-26, recalls the previous setup from the non-volatile
memory
5 Although in this example only one source is connected, you can connect all four inputs, that is, 12 in total
6 In this example a projector is used, but you can also connect separate outputs such as displays, video recorders and so on