Your VM-24HDMI 2 Input 1:4 HDMI Distributor
7
Table 1: VM-24HDMI 2 Input 1:4 HDMI Distributor Features
#
Feature
Function
1
IR Receiver
The red LED is illuminated when receiving signals from the Kramer
infrared remote control transmitter
2
POWER
Switch
Illuminated switch for turning the unit ON or OFF
3
IN 1
Button
1
Press to select source 1 and distribute this signal to the outputs
4
SELECT
IN 2
Button
1
Press to select source 2 and distribute this signal to the outputs
5
READ
2
Press, after pressing the EDID SELECT button, to acquire the EDID
Press to show the EDID status
6
EDID
Buttons
SELECT
Select the EDID mode (One Output, Auto-mix or Default)
7
OUTPUT STATUS
LEDs
LEDs light when an output(s) is connected and active; LEDs blink to
indicate the type of EDID acquired (see section 6.4) or when
connecting a non-HDCP display while providing HDCP content to
the
VM-24HDMI
8
INPUT 1
HDMI Connector
Connects to the HDMI source 1
9
INPUT 2
HDMI Connector
Connects to the HDMI source 2
10
OUTPUT
HDMI Connectors
Connects to the HDMI acceptor (from 1 to 4)
11
RS-232
9-pin D-sub Port
Connects to the PC or the Remote Controller
3
12
REMOTE IR
Opening
4
Connects to an external IR receiver unit for controlling the machine
via an IR remote controller instead of using the front panel IR
receiver
5
13
Power Connector with Fuse
AC connector enabling power supply to the unit
4.1 Using the IR Transmitter
You can use the
RC-IR2
IR transmitter to control the machine via the built-in
IR receiver on the front panel or, instead, via an optional external IR
receiver
6
. The external IR receiver can be located 15 meters away from the
machine. This distance can be extended to up to 60 meters when used with
three extension cables
7
.
Before using the external IR receiver, be sure to arrange for your Kramer
dealer to insert the internal IR connection cable
8
with the 3.5mm connector
that fits into the REMOTE IR opening on the rear panel.
Connect the external IR receiver to the REMOTE IR 3.5mm connector.
1 Illuminates when selected and there is a signal
2 Illuminates when configuring the EDID
3 Via a null-modem connection
4 Covered by a cap. The 3.5mm connector at the end of the internal IR connection cable fits through this opening
5 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if the internal
IR connection cable has been installed)
6 Model: C-A35M/IRR-50
7 Model: C-A35M/A35F-50
8 P/N: 505-70434010-S