Kramer VM-10H2, Руководство пользователя, Страница: 8 / 29

Kramer Electronics Ltd.
VM-10H2
– Connecting the VM-10H2
6
Connecting the VM-10H2
Always switch off the power to each device before connecting it to your VM-10H2 . After
connecting your VM-10H2 , connect its power and then switch on the power to each device.
To connect the VM-10H2:
1. Set the DIP-switches as needed (see Setting the DIP-Switches on page 7 ) .
2. Connect an HDMI source (for example, a Blu-ray player) to the INPUT connector .
3. Connect the ten OUT connectors to up to ten HDMI acceptors (for example, 4K
displays).
Not all outputs must be connected.
4. Connect the power cord to the mains electricity.
5. Turn ON the POWER .
6. Acquire the EDID (see Acquiring and Setting the Current EDID on page 8 ).
Figure 2: Connecting to the VM-10H2 Rear Panel
Connecting to VM-10H2 via RS-232
The VM-10H2 features an RS-232 3-pin terminal block connector allowing the RS-232 to
control the VM-10H2 .
Connect the RS-232 terminal block on the rear panel of the VM-10H2 to a PC/controller,
as follows:
•
TX pin to Pin 2
•
RX pin to Pin 3
•
GND pin to Pin 5
RS-232 Device VM-10H2
8
6
7
10
9