KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the VP211K Automatic UXGA / Audio Switcher
8
5.3 Connecting the REMOTE Terminal Block Connector
You can force the routing of one of the two inputs to the UXGA output by
remote control. To do so, connect the appropriate REMOTE input
terminal
block connector pins to a contact closure switch
1
. For example, as Figure 3
illustrates, to route REMOTE IN1 to the UXGA output, connect PIN IN1 to
PIN G (Ground). To route REMOTE IN2
to the UXGA output, connect PIN
IN2 to PIN G.
Do not connect both the REMOTE IN1 and the REMOTE IN2 to PIN G
simultaneously
Route input 1 to the output,
by attaching PIN IN1 to PIN
G:
Route input 2 to the output,
by attaching PIN IN2 to PIN
G:
Figure 3: REMOTE Terminal Block Connector
1 Note that the connection should be permanent, since the VP-211K will revert to an automatic switcher when the connection
is removed
