Using the VP211K Automatic UXGA / Audio Switcher
5
5 Using the VP211K Automatic UXGA / Audio Switcher
This section describes how to:
Connect the
VP-211K
(see section 5.1)
Select the default master source signal (see section 5.2)
Connect the REMOTE connector (see section 5.3)
5.1 Connecting the VP-211K Automatic UXGA / Audio Switcher
To connect the
VP-211K
, as illustrated in the example in Figure 2, do the
following
1
:
1.
Connect a UXGA/audio source (for example, a PC graphics card) to the
UXGA IN 1 15-pin HD connector and to the AUDIO IN 1 mini plug
connector.
2.
Set the DEFAULT INPUT switch to IN 1 (the factory preset default), as
section 5.2 describes.
3.
Connect a UXGA/audio source (for example, a PC graphics card) to the
UXGA IN 2 15-pin HD connector and to the AUDIO IN 2 mini plug
connector.
4.
Connect the UXGA OUT 15-pin HD connector and the AUDIO OUT mini
plug connector to the acceptor (for example, a display with speakers).
5.
If required, connect an additional display to the UXGA LOOP OUT
15-pin HD connector.
6.
Connect the 5V DC power adapter to the power socket and connect the
adapter to the mains electricity.
1 Switch OFF the power on each device before connecting it to your VP-211K. After powering up your VP-211K, switch on
the power on each device
