Connecting the SP-11HD HD-SDI Processor
9
9
6
Connecting the SP-11HD HD-SDI Processor
You can use your
SP-11HD
to convert
1
composite video, s-Video,
component video (YUV), or SDI signals to composite video (PAL or
NTSC), s-Video, component video (YUV) and
2
Figure 2
SDI, as well as to a
“Before/after” split-screen, as the example illustrates in
.
To connect
3
the
SP-11HD
Digital Video Processor
, do the following
4
1. Connect the following sources to the
SP-11HD
:
:
•
The composite video source (for example, a DVD player) to
the CV INPUT BNC connector
•
The s-Video source (for example, an S-VHS player) to the
Y/C INPUT 4-pin connector
•
The SDI source (for example, a digital video player) to the
SDI INPUT BNC connector
2. Connect the component video INPUTS BNC connectors, Y, B-Y, and
R-Y to YUV video source.
3. Connect the following acceptors to the
SP-11HD
:
•
The SPLITTER OUTPUT BNC connector to the split image
acceptor (for example, a display)
•
The Y/C OUTPUT 4-pin connector to an s-Video acceptor
(for example, a display)
•
The CV OUTPUT BNC connector to a composite video
acceptor (for example, a display)
•
The BNC OUTPUTS connectors: Y, B-Y and R-Y to a video
acceptor (for example, a plasma display)
•
The two SDI OUTPUTS BNC connectors to two serial digital
video acceptors (for example, two monitors: SDI 1 and SDI 2)
4. Connect a PC or other controller, if required (see section
6.1
).
5. Set the DIP-switches (see section
6.2
).
6. Connect the AC power cord.
1 The
SP-11HD
does not perform standard conversion or scaling. The output resolution is always identical to the input
resolution
2 All output formats are always available when the format is valid for the input resolution being used
3 When only one output is required, connect that output of the
SP-11HD
, and leave the other outputs unconnected
4 Switch OFF the power on each device before connecting it to your
SP-11HD
. After connecting your
SP-11HD
, switch on
its power and then switch on the power on each device
