#
Feature
Function
8
RS-232 3-pin Terminal Block Connectors
(Rx, Tx, GND)
Connect to RS-232 controlled devices (1 and 2, with common GND).
9
RS-485 3-pin Terminal Block Connector
Connect to the RS-485 terminal block connector on another device or PC.
10 I/O 2-pinTerminal Block Connector (GPIO,
GND)
Connect to a sensor or device to be controlled, for example, a motion sensor.
This port may be configured as a digital input, digital output, or analog input.
11 IR 2-pin Terminal Block Connectors
(Tx, GND)
Connect to an IR emitter cable (1 and 2, with common GND).
12 REL 2-pinTerminal Block Connectors
Connect to a device to be controlled by relay. For example, a motorized
projection-screen (1 and 2).
13 12V Power Supply 2-pin Terminal Block
Connector (+12V, GND)
Connect to a power supply: Connect GND to GND and 12V to 12V.
14 KNET 4-pin Terminal Block Connector
Connect the GND pin to the Ground connection; pin B (-) and pin A (+) are
for RS-485, and the +12V pin is for powering the connected unit.
15 Factory Reset Button
Press while connecting the power and then release to reset the device to its
default parameters.
To access this button, you need to remove the Button Faceplate.
16 Mini USB Type B Port
Connect to your PC for firmware upgrade or for uploading the configuration.
To access the USB port, you need to remove the Button Faceplate.
17 IR Sensor
For learning commands from an IR remote control transmitter.
18 Programing DIP-switch
For internal use.
Step 3: Configure RC-206
To configure RC-206 buttons
via
K-Config
:
•
Configure
RC-206
www.kramerav.com/product/K-Config
).
•
Connect
RC-206
to a PC via the Ethernet or connect via the mini USB port.
•
Sync the configuration to
RC-206
.
To insert a button label for the first time:
1. Cut out the appropriate button label from the button
label sheets and place a label inside the button cover
in the correct orientation (ledges are sideways).
2. Cover with the button cap in the correct orientation
(with ledges sideways).
To replace a label:
1. Using the supplied tweezers, grip the button via the
left and right ledges and remove the button cap.
2. Replace the label and cover the button with the
button cap.
You do not have to detach the faceplate to remove
a button.
