Kramer Electronics Ltd.
PA-120Net, PA-240Net
– Protocol 3000
31
Audio Commands
These commands are used by audio devices running Protocol 3000.
Command
Description
AUD-CH-LINK
Set/get link between master configuration and slave/state
AUD-CLIP?
Get clipping status
AUD-FILTER
Set/get filter/state
AUD-HI-Z?
Get High Z status
AUD-IN-CONF
Set/get threshold and time
AUD-LVL
Set/get audio level in specific amplifier stage
AUD-MIX
Set/get mixer level
AUD-MONO-MODE
Set/get output select state when audio in HI-Z mode only
AUD-SIGNAL?
Get audio input signal status
AUD-STANDBY
Set/get standby mode/state
BALANCE
Set/get balance level
EQ-FREQ
Set/get equalizer center
EQ-LVL
Set/get equalization level
EQ-Q
Set/get Q level
MUTE
Set/get audio mute
AUD-CH-LINK
Functions
Permission
Transparency
Set:
AUD-CH-LINK
End User
Public
Get
AUD-CH-LINK?
End User
Public
Description
Syntax
Set:
Set link between master configuration and slave
#AUD-CH-LINK
SP
Ch1
,
Ch2
,
LinkState
CR
Get:
Get the configuration link state
#AUD-CH-LINK?
Ch1
CR
Response
~
nn
@AUD-CH-LINK
SP
Ch1
,
Ch2
,
LinkState
CR LF
Parameters
Ch1
–
1
(Speaker Output)
Ch2
–
2
(Line Level Output)
LinkState
–
1
(enable),
0
(disable)
Notes
Response if no link -
AUD-CH-LINK 1,1,0
Response if link -
AUD-CH-LINK 1,2,1
K-Config Example
Set a link between the speaker output configuration and the line level output configuration:
“#AUD
-CH-
LINK 1,2,1”,0x0D