Kramer MV-6, Руководство пользователя

Страница: 16 / 75

12 MV-6 - Connecting the MV-6
5.2 Connecting via Ethernet
You can connect to the MV-6 via Ethernet using either of the following
methods:

Directly to the PC using a crossover cable (see Section
‎5.2.1
)

Via a network hub, switch, or router, using a straight-through cable (see
Section
‎5.2.2
)
Note : If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
5.2.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the MV-6 directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the MV-6
with the factory configured default IP address.
After connecting the MV-6 to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center .
2. Click Change Adapter Settings .
3. Highlight the network adapter you want to use to connect to the device
and click Change settings of this connection .
The Local Area Connection Properties window for the selected network
adapter appears as shown in Figure 4 .
i