Kramer Electronics Ltd.
K-Cam4K
– Operating and Controlling K-Cam4K
16
Configuring Communication Parameters
Define communication parameters.
To define communication parameters:
1. On the IR remote press
MENU
. The menu appears.
2. Use the arrows to select
COMMUNICATION SETUP
.
3. Click
HOME
to enter SETUP menu. Define the following:
Menu Item
Function
Protocol
Select the control protocol to VISCA, PELCO-D or PELCO-P.
V_Address
Set the number of a camera in a daisy-chain setting (1 to 7). Set the
first camera to 1 the second in the chain to 2, and so on (enabled in
Auto mode, when VISCA protocol is selected).
To daisy-chain cameras you need to use the VISCA protocol,
Net Mode to Serial and set the baud rate to 9600 (default).
V_AddrFix
Set to On or Off.
P_D_Address
Set from 0 to 254 (enabled in Auto mode, when PELCO-D protocol is
selected).
P_P_Address
Set from 0 to 31 (enabled in Auto mode, when PELCO-P protocol is
selected).
Net Mode
Set to serial port Network control to Serial or Paral.
Baudrate
Select 2400, 4800, 9600 or 38400.
Setup parameters are defined.
Restoring to Default Settings
To restore default settings:
1. On the IR remote press
MENU
. The menu appears.
2. Use the arrows to select
RESTORE DEFAULT
.
3. Click
HOME
to enter RESTORE DEFAULT menu.
4. Select Restore and then select
Yes
.
Default settings are restored.
Operating via Ethernet
You can connect to
K-Cam4K
via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see
Connecting Ethernet Port Directly to a
•
Via a network hub, switch, or router, using a straight-through cable (see
Ethernet Port via a Network Hub
Note
: If you want to connect via a router and your IT system is based on IPv6, speak to your
IT department for specific installation instructions.