#RVT-34-BW R.1 SEPTS 2018
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
GAS FIREPLACE INSERT SETUP
21
9.0 GAS FIREPLACE INSERT SETUP
9.1 Glass Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should be done
by a licensed or qualified service person.
9.1.1 Remove Glass Assembly
WARNING: Do not remove the glass assembly when hot.
1. Locate (2) spring-loaded latches securing the glass assembly at
the bottom of the firebox.
2. Using the glass latch tool (included in components packet), pull
the bottom latches out and up to release glass frame assembly
latch tabs.
3. Lift glass assembly up and off of the (2) tabs located at the top of
the firebox.
9.1.2 Install Glass Assembly
1. Verify bottom latches are pushed down to allow for easier
installation.
1. Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2. Using the glass latch tool, pull latches out and down over latch
tabs to secure glass frame assembly bottom.
9.2 Light Kit
CAUTION: Disconnect all electrical power from the fireplace before
performing this task.
ATTENTION: If converting to propane, complete the conversion before
installing any light kit components. Follow instructions provided with
the conversion kit (sold separately).
NOTE: To avoid damage and prolong the life of the halogen bulbs,
never touch with bare hands. Always use a soft cloth when handling.
9.2.1 Install Light Kit
1. Remove the safety barrier and glass frame assembly.
2. Remove ash panels and beach accent kit (if installed).
3. Lift up the log rack/ember media tray.
4. Install (2) halogen bulbs (included in components packet) into
the lamp bases.
5. Reinstall log/ember media tray. Center the tab on the bottom of
tray with the two tabs on the light kit housing.
6. Reinstall all components previously removed.
INSERT GLASS
LATCH TOOL HERE
LATCH TAB
Figure 9.1, Upper Tab
Figure 9.2, Latch Release
