kozy heat MPS-34 Minneapolis XL, Инструкция по установке и эксплуатации

Страница: 25 / 38

PAGE 24
IPI INFORMATION
MATCHING SECURITY CODES
REMOTE CONTROL OPERATION
INITIAL SET-UP:
NOTE: This system is sent to you set up for Natural Gas and
temperature units readable in Fahrenheit.
CELSIUS/FAHRENHEIT CONVERSION:
GAS TYPE CONVERSION:
Following LEARN BUTTON ACCESS PROCEDURES on previous page, press and hold LEARN Button on Main Control Module for
20 seconds. A beep will be heard letting you know the procedure has been completed.
If converting from NAT to LP gas: (1) one second long beep
If converting from LP to Nat gas: (3) three second long beep
Continue with gas type conversion by following instructions included with gas conversion kit.
Press UP and DOWN keys simultaneously to choose Celsius or Fahrenheit.
This system allows for gas type conversion and temperature unit conversion by following the setup procedure outlined below.
This system has a maximum room temperature limit of 95° F (35° C) in both manual and thermostat modes. When room temperature is
at or above this point the system will shut down and the hand held remote control will read
OFF . If you turn the system ON when room
temperature is still at or above this temperature, the system will again shutdown after 2 minutes when room temperature is recalculated.
IMPORTANT SAFETY FEATURE:
Plug Extension Module and AC Adaptor into receptacles.
Install (4) AAA batteries into battery compartment of
Backup Battery Pack , making sure batteries are installed in proper direction.
Position on right side access panel. A Velcro strip has been attached to help secure in place.
The
Hand Held Remote operates on (2) 1.5V AAA batteries. We recommend always using ALKALINE batteries to extend battery life and
improve operational performance.
Before matching security codes make sure 120V AC is connected and powered to fireplace, and hand held remote control is installed with
(2) AA batteries.
It may be necessary to program main control module (located on right side of firebox) to LEARN the hand held remote control security
code upon initial use, if batteries are replaced, or if a replacement remote control is purchased from your dealer.
1. When matching security codes, be sure slide button on main control module is in
REMOTE ; the code will not „LEARN‟ if slide is in
OFF.
2. Following LEARN BUTTON ACCESS PROCEDURES on previous page, program main control module to LEARN a new
security code by pushing in LEARN button on main control module using a pencil point for 2 seconds (you should hear a single
„beep‟ letting you know module is ready to learn a new code).
3. Press MODE button on hand held remote control (you should hear four „beeps‟ in rapid succession in main control module, indicating
remote control‟s code has been programmed into the main control module). When an existing main control module is introduced t o a
new hand held remote control, the new security code will overwrite the old one.
If it ever becomes necessary to clear the memory from the hand held remote control, simply push and hold the LEARN button for 10
seconds (you should hear three long beeps in succession). You may now follow steps outlined above to „RE - LEARN‟ security codes.