kozy heat MPS-34 Minneapolis XL, Инструкция по установке и эксплуатации

Страница: 24 / 38

PAGE 23
IPI INFORMATION
LEARN BUTTON ACCESS HOLE
LEARN BUTTON
SLIDE TO REMOTE POSITION
UPRIGHT ROTATED
Figure 23a
PRE-INSTALLATION POST-INSTALLATION
Prior to installation: Access through hole on right side of insert.
After installation: A. Remove screen front and glass frame assembly to expose components on right side wall of insert.
B. Move battery pack away from front of main control module.
C. Using a needle nose pliers, remove pilot connection tabs from main control module. Main control module
can now be rotated forward to access LEARN button.
D. Reattach pilot connection tabs (top-black, bottom-red), reattach battery pack and install glass frame
assembly and screen front.
LEARN BUTTON ACCESS PROCEDURE
ELECTRICAL WARNING AND INFORMATION:
Electrical wiring must be installed by a licensed electrician.
Do NOT wire 110V to wall switch.
Uninterrupted or continuous power is required at all times in IPI systems EXCEPT when using battery back-up.
Incorrect wiring will override IPI safety lockout and may cause an explosion.
Disconnect 110V before servicing.
The IPI gas control system has the option of a continuous (standing) pilot feature. This allows you to change from a spark-to-pilot
system to a standing pilot system during cold weather conditions. By having the pilot on continuously, the firebox will remain warm
and a draft is established in the vent, allowing the main burner to turn on with less air-flow disruption.
When continuous pilot mode is activated and fireplace is turned ON, the pilot will spark and light. When fireplace is turned OFF, the pilot
will remain lit when main burner has been turned OFF.
This pilot feature can be activated or de-activated by the hand held remote control transmitter. Instructions on page 25.
CONTINUOUS PILOT (
FOR VERY COLD CONDITIONS)
OPERATION USING BATTERY POWER
This fireplace has an optional battery operation if electrical power is lost. Battery pack is located on right access panel of firebox.
ATTENTION: This system goes through a calibration mode when switching from ON to THERMO to OFF, creating a humming
sound which is a normal part of operation.
NOTE: When operating fireplace in this capacity, the only function available is flame modulation.