kozy heat KOMFORT ZONE KIT KZK-050, Руководство пользователя

Страница: 1 / 28

HUSSONG MANUFACTURING CO., INC.
READ ALL THESE STEPS
BEFORE STARTING INSTALLATION.
LEAVE THESE INSTRUCTIONS WITH THE
APPLIANCE.
This kit must be installed by a qualified installer,
service agency, or gas supplier at the time of
the heater installation. These instructions must
be used in conjunction with the installation and
operation manual provided with the appliance.
Please read the appliance owner’s manual
completely before performing any procedures in
these instructions.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
KOMFORT ZONE KIT
#KZK-050
For use with the Callaway-50 #CLW-50
Direct Vent Gas Fireplace
This optional convection duct kit redistributes the
warm air flow away from the fireplace opening to
a more desirable location using natural convection
without the use of a fan. The warm air flow may be
relocated to a position higher up the wall, out the
sidewalls, or even to an adjacent room. The result
is much cooler wall temperatures above the fire -
place opening for locating televisions, artwork, etc.
The use of this kit will permit lower mantel clear
-
ances to be used. These lower mantel clear-
ances must be only used when the KZK Duct
system is installed.
English and French installation manuals are available through your
local dealer. Visit our website www.kozyheat.com .
Les manuels d’installation en français et en anglais sont disponibles
chez votre détaillant local. Visitez www.kozyheat.com.
Hussong Manufacturing Co., Inc.
P.O. Box 577, 204 Industrial Park Drive
Lakefield, MN 56150-0577, USA
Rev. 2, 5/19
1.0 INTRODUCTION .......................................................................3
1.1 Kit Contents.......................................................................................... 3
1.2 Suggested Configurations .............................................................. 4
1.3 Dimensions and Overview ............................................................. 5
1.4 Air Duct Run ......................................................................................... 6
2.0 FRAMING AND CLEARANCES ................................................7
2.1 Clearance to Sprinkler ...................................................................... 7
2.2 Framing.................................................................................................. 8
3.0 FACING AND FINISHING .........................................................9
3.1 Non-combustible Requirements .................................................. 9
3.2 Combustible Finish ..........................................................................10
4.0 INSTALLATION .......................................................................12