16
#936-50E LOG SET INSTALLATION
Figure 16a
ATTENTION
If converting to LP (propane) gas, do so now before installing log set. Follow instructions included with conversion kit.
CAUTION
Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
NOTE
Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
Position top logs X9 & X10 onto alignment cut-outs on base and middle logs.
Place klinkers along front of burner cover directly behind log grate.
Brush additional Rockwool embers onto logs
.
X7
X4
X2
X1
X8
X10
X9
X3
Position base logs onto burner cover in following order: X1, X2, X3 & X4. Align mounting holes in
bottom of logs to corresponding mounting studs. Pull X1 log forward toward burner tube.
Brush Rock wool embers onto burner and base logs with a stiff bristle brush.
X6
Position X6, X7, & X8 logs onto alignment cut-outs on base logs.
klinkers
Figure 16b
Figure 16c