Kozlusan SLIMPEL, Руководство пользователя

Страница: 12 / 21

Page 12
INSTALLATION
Your KOZLUSAN heating system should be installed by a qualified heating contractor who is thoroughly
familiar with gas, oil, and solid fuel heating appliances. Also, you should be sure to comply with local
building codes, fire codes and other regulations when installing the heating system.
Safe Practices
 Hire a licensed contractor with experience in design and installation automated heating systems.

Comply with local building codes, fire codes and other regulations when installing this heating system.
 Observe minimum clearances to combustible surfaces.
 Make sure to identify sources of make-up air in the room where the heating system is located. The
KOZLUSAN Heating System, exhaust fans and other appliances all draw air from the room. Be certain
there is an adequate source of fresh air to offset these demands or you may create negative pressure in
the room and starve the heating system of combustion and create draft problems in your flue.
 Connect the heating system to a properly installed and operating chimney and vent it to the outside.
 Be sure your chimney is safely constructed and in good repair. Before installation, have the chimney
inspected by a qualified inspector.
 Be sure to provide thermal spike protection for the heating system (see Wiring and Controls pg. 30).
 DO NOT connect the heating system to an aluminum Type B gas vent.

DO NOT vent the heating system to another room or inside a building.
 DO NOT share a chimney flue with another appliance.

DO NOT install the heating system in a mobile home or trailer. Instead, install the heating system
outside in a covered enclosure and pipe the hot water into the mobile home.