KOS Quadrat, Руководство по установке, использованию и обслуживанию

Страница: 28 / 64

28
Introduction
In addition to its installation, a very important step
that is often underestimated, is the system constant
and continuous maintenance.
Before filling the pool with mains or well water, make
sure that the water is clear. Cases of mains water
particularly coloured by suspended sediment of
different nature are not uncommon. If this type of
water is being supplied, the use of an appropriate
filter is recommended on the water supply line.
In any case, the pool water is still exposed to sun and
air, not to mention bathers as well.
Therefore, two common phenomena occur:
1) Pollution due to bacteria in the atmosphere
and in water itself, in addition to those
introduced by bathers that, without adequate
water circulation, will stagnate and, without
necessary oxygenation, allow the reproduction
of micro-organisms, mainly plant-type (algae).
The higher the ambient temperature is, the faster
this phenomenon will occur.
The results are: a green colour of the water and a
deposit of slimy and slippery organic substances
on the surface of the pool.
2) Pollution due to inert solid substances: dust,
soil, leaves etc. carried by wind, rain and bathers
that cloud the water.
Questi due fattori che incidono sull’acqua della
minipiscina, deteriorano in poche ore o in pochi
giorni la qualità dell’acqua con il seguente risultato:
una piscina totalmente antigienica e per niente
invitante per il bagno.
Initial filling
(this is the responsibility of the installer)
1. Before filling, make sure the tub and the filter are
clean; if necessary, clean them with a suitable
product. For tub cleaning, apply the product
directly onto the surface to be cleaned; do not use
abrasive applicators. Allow the product to act for
a few minutes, then rinse thoroughly with water.
2. As soon as possible and in any case, once the filling
of the tub is completed, enable water circulation
and add about 200 ml of EVERSAN MET I for every
1,000 litres of water.
3. Check the pH level of the water and take it to a 7.4
- 7.6 range with the addition of suitable product.
4. Perform an intensive treatment by adding 8-10
SURCHLOR D tablets every 1,000-1,500 litres of
water. For the minipool, dissolve 28 tablets in a
bucket with warm water and add the solution
directly to the pool. The best time to carry out an
intensive treatment is at the end of the day, when
the pool is not being used.
NOTE: Remove the cover of the tub before adding
SURCHLOR D or EVERBROM and always let water
circulate for at least 30 minutes after treatment
before covering it again.
Keyboard controls
(only versions “Standard and Full op-
tional”)
You cannot access the keyboard controls from inside
the minipool.
This can be accessed through an “inspection com-
partment” (see previous instructions).
For this reason, you should set the main values before
entering the water.
Some functions can be changed from inside the
minipool.
CAUTION:
Before powering the control unit, it is necessary to
check that:
• The water level in the pool is sufficient.
• All the hydraulic system valves are open.
• There are no elements that could obstruct the
water flow inside the tubes.
This is how the keyboard appears:
GB - Instructions for use and maintenance
Quadrat
KEYBOARD:
1 - Pump 1
2 - Pump 2
3 - airpool
4 - chromotherapy
5 - heater indicator
6 - increase (UP)
7 - decrease (DOWN)
KOS
Minipool
1 2 3 4
5 6 7
(key only active for Full
optional version)