7
9
OPERATING INSTRUCTIONS
•
Water Entering:
After fixing all the pipes, then make
the cold and hot water-blending valve rotate to
the high temperature sector according to the
clockwise direction. And reopen the cold
water pipe's water entering valve. At this time,
the electrical water heater's tank will start to enter
the water. Waiting that the shower sector of the
water exiting mouth is in normal condition,
which indicates that the tank has full filled with water
Cautions:
During the electrical water heater is in the normal operating
procedures, the water-entering valve of the cold water pipe's mouth-
entering sector must be in the open condition from the beginning to the
end. At this time, the water-entering valve can still make the functions of
regulating the water-existing mouth section's flowing strength and
weakness. However, the cold and hot mixed water valve can only regulate
the water temperatures and make the function of closing the water exiting.
•
Plug into the Power Source:
After confirming the tank to be fully filled the
water, you can make the power source's plug into the outlet and put
through the power sources.
•
Hot water operations:
After the electrical water heater normally works
and the heats for a long period of time, you can use the hot water in the
tank, you need to make the cold and hot mixed valve rotate with the
clockwise direction slowly from the low temperature to the high
temperatures in the closed condition. And adjust it to your proper
temperature. At that time, the shower mouth can come out the hot water.
After finishing the uses, you can turn it to the closed section by the anti-
clockwise direction and shut off the mixed water valve.
Cautions:
When adjusting the water temperature of the water-exiting
mouth, you don't make the shower directly to the human body; you should
test the water temperature first to avoid burning to damages.
•
Overheating Protections:
Under the condition of putting through the
power, but the heating pipe won't heat from the beginning to the end. That
means the two power-selecting switch will be in the putting through
position. At this time, it may appear the over heat protections (that is to
make functions by the double-positional temperature-limiting protection
switch).
