Korman 504101, Оригинальное руководство пользователя

Страница: 5 / 32

5
EN
- the 1/4’’ thread on the back of measuring tool (e.g.
when measuring from a tripod),
- the front measuring-tool edge (e.g. when measuring
onward from a table edge).
Note: when the selected reference level is the front
measuring-tool edge, the measurement is taken from the
laser lens, and not from the housing of the tool (setback
of 7 mm).
To change the reference level, press button (6) until
the requested reference level is indicated on the display.
Each time after switching on the measuring tool, the rear
end of the measuring tool is preset as the reference level.
Length measurement
1. Press button (1)
MEASURE
ON
to acti-
vate the laser, and aim at the object
which is to be measured.
2. Press button (1)
MEASURE
ON
again
to take measurement. The measured
value is indicated at the bottom in the
display.
Calculation function (+/-)
1. After switching on, when you want to measure the total
distance, after you measure the first distance, press
+
,
then again press button (1)
MEASURE
ON
to measure the dis-
tance you want to add, it can calculate automatically, the
result is displayed.
2. After switching on, when you want to measure the
short distance, after you measure the first distance,
press - , then again press button (1) MEASURE
ON
to mea-
sure the distance you want to sub, it can calculate auto-
matically, the result is displayed.
Area measurement
1. After switching on, press button (2)
FUNC
until the indi-
cator for area measurement appears on the display.
2. Press button (1)
MEASURE
ON
to measure the length and
the width, one after another, in the same manner as a
length measurement. The laser beam remains switched
on between both measurements.
After taking the second measure-
ment, the area/surface is automatical-
ly calculated and displayed. The last
individual measured value is indicated
at the second line in the display, while
the final result is shown at the bottom.
Volume measurement
1. After switching on, press button (2)
FUNC
until the
indicator for volume measurement appears on the
display.
2. Press button (1)
MEASURE
ON
to measure the length,
width and the height, one after another, in the same
manner as for a length measurement. The laser beam
remains switched on between all three measurements.
After taking the third measurement,
the volume is automatically calcula-
ted and displayed. The last individual
measured value is indicated at the
middle line in the display, while the
final result is shown at the bottom.
Indirect length measurement
The indirect length measurement is used to measure
distances that cannot be measured directly because an
obstacle would obstruct the laser beam or no target sur-
face is available as a reflector. Correct results are achie -
ved only when the laser beam and the sought distance
from an exact right angle (Pythagorean theorem).
Indirect measurement: Pythagoras with two refe-
rence points
As shown in the picture, if user wants to measure the
height of a building, he can use Pythagoras to calculate
the height.
1. After switching on, press button
(2)
FUNC
three times, the symbol
appears.
2. Press button (1)
MEASURE
ON
to acti-
vate the laser and aim at the point
which is to be measured.