Korenix JetLink 1102, Руководство пользователя

Страница: 23 / 52

JetLink 1102/ JetLink 1302 User Manual
23
Once the wall mounting plates are secure on the device, you will need to attach the
wall screws (x4).
6. Locate the installation site and place the fieldbus gateway against the wall, mak-
ing sure it is the final installation location.
7. Use the wall mount plates as a guide to mark the locations of the screw holes.
8. Drill four holes over the four marked locations on the wall, keeping in mind that
the holes must accommodate wall sinks in addition to the screws.
9. Insert the wall sinks into the walls.
10. Insert the screws into the wall sinks. Leave a 2 mm gap between the wall and
the screw head to allow for wall mount plate insertion.
Note!

Make sure the screws dimensions are suitable for use with the wall mounting
plate.

Do not completely tighten the screws into the wall. A final adjustment may be
needed before fully securing the wall mounting plates on the wall.
11. Align the wall mount plate over the screws on the wall.
12. Install the wall mount plate on the screws and slide it forward to lock in place,
see the following figure.
13. Once the device is installed on the wall, tighten the screws to secure the
device
.