Installation instructions
67
13. Fixing the KORASMART 1200 (1200T)
device to the wall
• Lift the device and make the pipe fixed to it slide into the
wall passage, see point 9.
• Push the device slightly downwards and fix it to the wall
with three fixing screws.
• Check if the device is properly seated at its place.
14. Mounting the exterior cover
• Use the caulking gun to apply permanently elastic sealant
on the outer edge of the pipe.
• Make sure the slats of the cover grid are situated face
down .
• Push the cover grid firmly against the pipe while two of its
clips must be fitted above the central partition of the pipe
and one clip under it .
• Seal any empty spots between the pipe and the wall with
permanently elastic sealant .
15. Putting the device into operation
• Connect the power supply of the device into the wall
socket of the AC 230 V mains. If you have mounted the
device in protected area II, the socket must be placed in
protected area III .
• The device is now ready to be used.
