temperature of the evaporator and the ice
making water is gradually decreasing;
The fan is running normally, and there is
stable air flow in the inlet and outlet of the
ice machine;
The ice machine has no abnormal noise;
The ice machine has no abnormal
vibration;
It takes about 10 to 20 minutes to make
one batch ice, depending on the ambient
temperature and the temperature of the
water. The higher the temperature is, the
longer the ice making will take;
Ice cube can be properly defrosted from
the machine.
Operation Instruction
Startup:
after proper installation, connect
the water source and turn on the power
supply, the machine will start working.
Please confirm that the machine is
operating normally when you turn it on for
the first time.
Note: In case of thunderstorm or not in
use for a long time, please disconnect the
power and water source!
Self-check:
with power on for the first time,
the ice maker will do self-check and pump
out remaining water.
Preparing:
after the ice machine is
energized, the inlet valve opens and the
inlet water will flow in until it reaches the
set level; then the ice maker will do
defrosting one time.
Ice making:
after pre-cooling for 30
seconds, the water pump starts, the water
flows through the evaporator smoothly and
evenly, the ice cubes are gradually formed
in the ice cube tray.
Ice Harvest
: after the ice making process,
the water pump is turned off, the
defrosting valve is turned on, and after the
hot gas enters into the evaporator for
about 1-2 minutes, the ice cubes slides
from the evaporator into the ice bin.
Warning: Do not put your hand into the
ice bin during the harvest process to
prevent the ice from hitting your hand!
Shutdown:
The ice maker will stop
worki
ng when you click the “on/off” button
on the panel during running process.
Bin full stop:
in the running state, with the
ice bin filled to a certain height, the ice
sliding board cannot or reset because of
the block of the freshly produced ice cubes,
the ice maker will stop in 30 seconds.
Repeat ice-making:
when the ice cubes
on the ice sliding board are taken away,
the ice maker will back to ice making
process in a few seconds.
Содержание CIM-210
Страница 7: ...Schematic Diagram of Installation NPT THREADS...
Страница 18: ......
