RAK-100S-DNV - User Guide, Rev. 1.0
// 27
5.1.
Opening and Closing the Chassis
The RAK-100S-DNV is factory configured to meet customer requirements. Kontron does
not recommend opening the system as this may cause damage to internal components.
Before opening the RAK-100S-DNV, the system must be switched off and disconnected
from the main power supply. Also, disconnect all peripheral devices from the RAK-
100S-DNV. Before you begin, ensure that you have a clean, flat and ESD-safe surface to
work on.
For opening and closing the RAK-100S-DNV, please perform the following steps:
1.
Close all applications. Shut down the system properly and disconnect the connection to the main power source.
Disconnect all peripherals.
2.
The RAK-100S-DNV should lay on a flat, clean surface with the access cover facing upwards.
3.
Loosen the hand-screw knobs (two located on the rear side), that secure the access cover to the chassis.
Figure 6: Descrewing the access cover of the RAK-100S-DNV
4.
Slightly slide the access cover rearward to disengage it from the chassis and then lift the access cover up.
Figure 7: Disengaging the access cover
