RAK-100S-DNV - User Guide, Rev. 1.0
// 25
4.4.2.
SATA Power Connector & SATA Power Cable
The RAK-100S-DNV provides six 7-pin SATA 3.0 data connectors (Figure 4, pos. 2), four SATA power cables (Figure 4,
pos. 3) and two dual 2.5" HDD / SSD brackets (Figure 4, pos. 7) for installing up to four 2.5" SATA HDDs / SSDs.
4.4.3.
M.2 Socket
The RAK-100S-DNV reserves one M.2 Key B socket (Figure 4, pos. 4), allowing the expansion with a Type 22x80 M.2
SSD drive.
4.4.4.
mSATA / mPCIe Socket
The RAK-100S-DNV reserves one mSATA / mPCIe combo socket (Figure 4, pos. 5), allowing itself being extended with
a full-sized mSATA SSD or a full-sized mPCIe WLAN / WLAN + Bluetooth card.The switch between mSATA and mPCIe
can be configured via jumper JP1. In case of installing an mPCIe WWAN modem card, an additional SIM card cage is
required (it must be so stipulated when ordering).
Figure 5: mSATA / mPCIe Selection Jumper JP1
Table 1: Pin Assignment JP1
Jumper Position
Description
Pin 1-2
Pin 2-3
X
-
mPCIe
-
X
mSATA
“
X” = Jumper set (short) and “-” = jumper not set (open)
4.4.5.
PCIe x16 Add-on Card Slot
The RAK-100S-DNV provides one PCIe x16 add-on card slot (Figure 4, pos. 6) for network, storage, graphics, video or
other functional expansion. It is accessible from the rear I/O panel. The slot supports only x8 signal.
The PCIe x16 slot is located on the riser card. There are two PCIe x16 slots on the riser card.
Only the upper one is functional.
2
3
1
