Kontron MSH8900, Руководство пользователя

Страница: 51 / 77

MSH8900
www.symkloud.com // 51
3.5. Configuring Chassis ID
A stack can contain up to 8 MS2900 systems. To configure the chassis ID of an MS2900 before including it in a stack:
Not possible through a Web interface ShMC CLI (serial, SSH)
To configure the chassis ID:
ipmitool> raw 0x3e 0x0F 0xB4 0x90 0x91 0x8B 0xE0
<Chassis No. (1-8)>
To display the chassis ID:
ipmitool> raw 0x3E 0x10 0xB4 0x90 0x91 0x8B 0xE0
Notes
When you are done, disconnect all the power cords of the unit
for which you just changed the chassis ID. Then reconnect the
power cords.
3.6. Configuring Rear and Front Uplinks (MS2900)
The Symkloud MS1300 platform does not support any additional uplink modules.
The SYMKLOUD MS2900 by default.
When the front uplinks of a hub are used, the rear SFP+ uplinks of an optional MSU8700 uplink module attached to it
cannot be used and vice versa.
3.6.1. Front Uplinks
To toggle uplinks from rear to front:
Not possible through a Web interface ShMC CLI (serial)
If hub is located in leftmost slot:
ipmitool> raw 0x3e 0x20 0xC0 0x00
If hub is located in rightmost slot:
ipmitool> raw 0x3e 0x20 0xC5 0x00
To perform a power cycle for the change to take effect, the hub
must be in standby mode (blinking green LED on hub). Refer to
Table 15 for a description of LED statuses:
ipmitool> power cycle