MOPSlcd6
User Information
p588m115.doc
JUMP
tec
Industrielle Computertechnik AG
Page: 4 of 42
2. USER INFORMATION
Copyright 1999 JUMP
tec
®
Industrielle Computertechnik AG.
In this document
JUMP
tec
®
Industrielle Computertechnik AG will also be referred to by the short form
"
JUMP
tec
®
".
The information in this document has been carefully checked and is believed to be accurate and
reliable. However, no responsibility is assumed for inaccuracies. Furthermore,
JUMP
tec
®
reserves the
right to make changes to any portion of this manual to improve reliability, function or design.
JUMP
tec
®
does not assume any liability for any product or circuit described herein.
2.1 Trademarks
AT and IBM are trademarks of International Business Machines
XT, AT, PS/2 and Personal System/2 are trademarks of International Business Machines Corporation.
Microsoft is a registered trademark of Microsoft Corporation.
Intel is a registered trademark of Intel Corporation.
All other products and trademarks mentioned in this manual are trademarks of their respective owners.
The reproduction, transmission or use of this document or its contents is not permitted without
expressed written authority.
Offenders will be liable for damages. All rights created by patent grant or registration of a utility model
or design, are reserved.
(C)
JUMP
tec
®
AG 1999
2.2 General
For the circuits, descriptions and tables indicated no responsibility is assumed as far as patents or
other rights of third parties are concerned.
The information in the Technical Descriptions describes the type of the boards and shall not be
considered as assured characteristics.
The reproduction, transmission or use of this document or its contents is not permitted without express
written authority. Offenders will be liable for damages. All rights, including rights created by patent
grant or registration of a utility model or design, are reserved.
(C)
JUMP
tec
®
AG 1999
2.3 Warranty
Each board is tested carefully and thoroughly before being shipped. If, however, problems should
occur during the operation, please check your user specific settings of all boards included in your
system. This is often the source of the fault. If a board is defective, it can be sent to your supplier for
repair. Please take care of the following steps:
1. The board returned should have the factory default settings since a test is only possible
with these settings.
2. In order to repair your board as fast as possible we require some additional information
from you. Please fill out the attached Repair Form and include it with the defective board.
3. If possible the board will be upgraded to the latest version without additional cost.
4. Upon receipt of the board please be aware that your user specific settings were changed
during the test.
Within the warranty period the repair is free of charge as long as the warranty conditions are
observed. Because of the high test expenditure you will be charged with the test cost if no fault is
found. Repair after the warranty period will be charged.
