MOPSlcd6
BIOS-Description
p588m115.doc
JUMP
tec
Industrielle Computertechnik AG
Page: 18 of 42
I/O Device Configuration sub menu:
Feature
Option
Description
Local Bus IDE adapter
Disabled
Enabled
Enables onboard PCI IDE device.
Floppy disk controller
Disabled
Enabled
Enables onboard FDC controller.
Base I/O address
Primary
Secondary
Selects base address of onboard FDC
conroller. (Primary = 3F0h, Secondary = 370)
Serial port A
Serial port B
Disabled
Enabled
Auto
OS Controlled
Disabled turns off the port.
Enabled requires end user to enter the base
I/O address and the IRQ.
Auto makes the BIOS configure the port.
OS Controlled lets the PNP OS configure the
port after bootup.
Base I/O address
3F8h, 2F8h, 3E8h, 2E8h
Select I/O base of port.
IRQ (port A and B)
IRQ 3, IRQ 4
Select IRQ of port A and B
Parallel Port
Disabled
Enabled
Auto
OS Controlled
Disabled turns off the port.
Enabled requires end user to enter the base
I/O address and the IRQ.
Auto makes the BIOS configure the port.
OS Controlled lets the PNP OS configure the
port after bootup.
Mode
Output only
Bi-directional
ECP
EPP
Set the mode for the parallel port.
Base I/O address
378h, 278h, 3BCh
Select I/O base of port.
IRQ
IRQ 5, IRQ 7
Select IRQ of parallel port.
DMA
DMA0, 1, 2, 3
Select DMA channel of port if in ECP mode.
USB Host Controller
Disabled
Enabled
Enable or Disable onboard USB controller.
USB BIOS Legacy Support*
Disabled
Enabled
Enable or Disable support for USB keyboard
and mice. Enable for use with non-USB aware
OSes such as UNIX and DOS.
8
Watchdog Settings
sub menu
Opens Watchdog Settings sub menu
*) NOTE: If USB legacy support is enabled, IRQ12 is used by the usb ohci controller. If you run
a system with win9x and without a mouse attached, set irq12 to reserved in the PCI/PNP ISA
IRQ Exclusion sub menu to prevent win9x from allocating irq12 for pci devices!
Watchdog Settings sub menu:
Feature
Option
Description
Mode
Disabled
Reset
NMI
Select watchdog operation mode.
Delay
1s, 5s, 10s,
30s
, 1min, 5min,
10min, 30min
The time until the watchdog counter starts
counting. Useful to handle longer boot times.
Timeout
0.4s, 1s, 5s, 10s,
30s
, 1min,
5min, 10min
Max. trigger periode.
