mITX-SKL-H – User Guide, Rev.1.1
www.kontron.com
// 87
Function
Second level Sub-screen / Description
HD Audio
Configuration>
(continued)
HD Audio DSP
Features
Configuration>
(continued)
Icepower IP EFX sub module>
Icepower IP SFX sub module>
Custom Module ‘Alpha’>
Custom Module ‘Beta’>
Custom Module ‘Gamma’>
Serial IO
Configuration>
I2C0 Controller1>
Enables/disables Serial IO controller
Following devices depend on each other:
I2C0 and I2C1;2;3
UART0 and UART1, SPIO, SPI1
UART2 and I2C4, I2C5
I2C1 Controller2>
I2C2 Controller3>
SPI0 Controller>
SPI1 Controller>
SPI2 Controller>
UART0 Controller>
UART1 Controller>
UART2 Controller>
GPIO Controller>
Enable /disable the GPIO controller
Serial IO I2C0
Settings>
I2C IO Voltage Select>
Select 1.8 V or 3.3 V for the
controller
Connected Device>
Indicate what type of device is
connected to this serial IO controller
Serial IO I2C1
Settings>
I2C IO Voltage Select>
Select 1.8 V or 3.3 V for the
controller
Connected Device>
Indicate what type of device is
connected to this serial IO controller
Serial IO SPI0
Settings>
ChipSelect Polarity>
Sets initial polarity for ChipSelect
signal
Serial IO UART0
Settings>
Bluetooth Device>
Enable/disable the vendor sensor
Wireless Charging Mode>
Set the wireless charging mode
Hardware Flow Control>
When enabled configures additional
2 GPIO pads for use as RTS/CTS
signals for UART
Serial IO GPIO
Settings>
GPIO IRQ Route>
Route all GPIO to one of the IRQ
WITT/MITT Test
Device>
Choose if WITT Device is used and with which controller
UART Test Device>
Choose if UART test device is used and with which controller
Additional Serial IO
Device>
When enabled, ACPI will report additional devices connected to Serial IO
