Kontron cPCI-DMXS64GX, Техническое справочное руководство

Страница: 79 / 139

cPCI-DMXS64GX Technical Reference Manual
3.36
3.5.3. J5 Signal Specification
3.5.3.1. IDE 0 Interface
Signal Pin Assignation Description
IDE0:RESET# A1 Reset
IDE0:RESET# B1 Reset
IDE0:D0-D15
B4, E3, C3, A3, D2,
B2, E1, C1, D1, A2,
C2, E2, B3, D3, A4,
D4
Prim. Disk Data – These signals are used to transfer
data to or from the IDE device.
IDE0:REQ A5
Prim. Disk DMA Request - This signal is directly
driven from the IDE device DMARQ signal. It is
asserted by the IDE device to request a data
transfer.
IDE0:IOW# C5
Prim. Disk I/O Write – In normal IDE mode, this is the
command to the IDE device that it may latch data
from SDD lines.
IDE0:IOR# E5
Prim. Disk I/O Read – In normal IDE mode, this is
the command to the IDE device that it may drive data
on SDD lines.
IDE0:IORDY B5
Prim. I/O Channel Ready – In normal mode, this
input signal is driven directly by the corresponding
IDE device IORDY signal.
IDE0:DACK# D5
Prim. DMA Acknowledge – This signal directly drives
the IDE device /DMACK signal. It is asserted to
indicate to IDE DMA slave devices that a given data
transfer cycle is a DMA data transfer cycle.
IDE0:IRQ14 E4 IRQ14 line
IDE0:IOCS16# A6 IOCS16 line
IDE0:A0-A2 D6, C7, E6
Prim. Disk Address – These signals indicates which
byte in either the ATA command block or control
block is being addressed.
IDE0:CS1# - CS3 A7, B7 Primary Chip Select - For ATA control register.
IDE0:PDIAG# C6 Passed Diagnostic