Kontron CP6016, Руководство пользователя

Страница: 32 / 40

CP6016 Introduction
ID 1022-3074, Rev. 2.0 Page 1 - 11
P R E L I M I N A R Y
Interfaces
CompactPCI
Compliant with CompactPCI Specification PICMG
®
2.0 R 3.0:
•
System controller operation
•
64-bit / 66 MHz PCI or PCI-X master interface with dedicated PCIe-to-
PCI-X bridge from Pericom (PI7C9X130)
•
3.3V or 5V signaling levels (universal signaling support)
Compliant with the Packet Switching Specification PICMG 2.16.
When installed in a peripheral slot, the CP6016 is isolated from the CompactPCI
bus. It receives power from the backplane and supports rear I/O and, if the system
supports it, packet switching (in this case up to two channels of Gigabit Ethernet).
Rear I/O The following interfaces are routed to the rear I/O connectors J3, J4 and J5:
•
COM1 and COM2 (RS-232 signaling); no buffer on the rear I/O module
is necessary
•
4 x USB 2.0
•
CRT VGA
•
PS/2 (mouse / keyboard)
•
2 x Gigabit Ethernet (compliant with PICMG 2.16)
•
4 x SATA (RAID 0/1/5/10 support)
•
PMC / XMC rear I/O
•
High Definition Audio (HDA) for codec integration
Hot Swap Compatible
The CP6016 supports System Master hot swap functionality and application-
dependent hot swap functionality when used in a peripheral slot.
When used as a System Master, the CP6016 supports individual clocks for
each slot and the ENUM signal handling is in compliance with the PICMG 2.1
Hot Swap Specification.
VGA ATI ES1000 2D graphics accelerator:
•
Supports resolutions of up to 1600 x 1200 by 16-bit color resolution
at a 75 Hz refresh rate or up to 1280 x 1024 by 32-bit color resolution
at a 75 Hz refresh rate.
•
The graphics controller provides 64 MB video memory.
•
One CRT controller capable of supporting two identical simulta-
neous display paths
Gigabit Ethernet
Five 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on one Intel® 82574L and two Intel® 82571EB Ethernet PCI Express
bus controllers:
•
Three RJ-45 connectors on the front panel
•
Two channels on the rear I/O
•
Automatic mode recognition (Auto-Negotiation)
•
Automatic cabling configuration recognition (Auto-MDI/X)
USB
Seven USB ports supporting UHCI and EHCI:
•
Two type A USB 2.0 connectors on the front panel
•
One onboard USB 2.0 connector for the USB 2.0 NAND Flash module
•
Four USB 2.0 ports on the rear I/O interface
Serial Two 16C550-compatible UARTs (RS-232 signaling):
•
One on the front panel and routed to rear I/O
•
One on the rear I/O
Table 1-1: CP6016 Main Specifications (Continued)
FEATURES SPECIFICATIONS