CP6000
System Considerations
ID 27942, Rev. 05
© 2005 Kontron Modular Computers GmbH
Page 7 - 7
2794
2.05.UG.VC.051020/17275
8
P R E L I M I N A R Y
Figure 7-1: Pentium® M Temp. Vs. Airspeed Graph with Standard Heat Sink
Figure 7-2: Pentium® M Temp. Vs. Airspeed Graph with E2 Heat Sink
Warning!
1) T
a
is the initial temperature of the ambient air used for convectional cooling
of the board. In a typical installation where the board is mounted vertically
in a system rack, this would be the temperature of the air measured at the
bottom of the board before the air flows over the board.
2) If the board is to be operated within the shaded area indicated above, it is
imperative to verify that it can be safely operated before the board is inte-
grated in an application system. This will require an empirical thermal
design analysis and verification by the system designer.
Dual Ethernet Controller
CPU
1 x Ethernet (1 x front and 1 x rear)
2 x Ethernet (2 x front and 2 x rear)
1)
2)
1)
2)
1)
2)
1)
2)
CPU
Dual Ethernet Controller
1 x Ethernet (1 x front and 1 x rear)
2 x Ethernet (2 x front and 2 x rear)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com