Operating the Unit
68
AM4904 User Guide
www.kontron.com
Now the status and configuration output should look like this:
# clicm clock reference show
SOURCE INFO VALUE DESCRIPTION
========= ==================== ========== ========================================
PRIMARY PLL reference input 0x02
PRIMARY SOURCE 0x0d FRONT
PRIMARY FREQ. 0x1f40 8kHz
PRIMARY OOR Limit 0x03 64-83 (+/-ppm)
PRIMARY Failure Indication 0x00
PRIMARY Failure Mask 0x0f SCM, CFM, GST, PFM,
SECONDARY PLL reference input 0x03
SECONDARY SOURCE 0x00 NONE
SECONDARY FREQ. 0x00
SECONDARY OOR Limit 0x03 64-83 (+/-ppm)
SECONDARY Failure Indication 0x0f SCM, CFM, GST, PFM,
SECONDARY Failure Mask 0x0f SCM, CFM, GST, PFM,
# clicm clock config show
STATUS VALUE DESCRIPTION
========================== ======== ================================================
PLL Mode 0x03 Automatic Normal Mode
PLL Holdover Mode 0x00 not detected
PLL Lock Mode 0x01 detected
Reference Select Fail 0x00 not detected
PLL Pull-in range 0x03 +/- 83 ppm (Stratum 4, G.824)
Reference Switch Mask 0x0c GST, PFM,
Reference Holdover Mask 0x03 SCM, CFM,
Wait to Restore 0x00 0 min
Disqualify time 0x0a 2.5 s
Qualify time 0x01 4 * 2.5 s
Hitless Switching 0x00 enabled (build-out phase differents)
Bandwidth 0x01 1.7 Hz
Phase slope limits 0x03 unlimited
Holdover update time 0x00 26 ms
Holdover filter bandwidth 0x00 bypass, no filtering
The output displayed by the commands “clock reference show” and “clock config show” are values read from
PLL (ZL30143). For more information about these values, please refer to the PLL manual.
Enable clock signal to AMC input
The output buffers to the AMC clocks (CLK1 and CLK2) can be selected independently. The supported devices
are: 1=AMC1, 2=AMC2, 3=AMC3 …
The output signal frequencies of the PLL to source the AMC’s can be selected from the following predefined
values:
• 8khz
• 1544khz
• 2048khz
• 19440khz
# clicm clock output
Set clock output driver and select frequency
clock output <DEVICE> {clk1|clk2} {8khz|1544khz|2048khz|19440khz}
Содержание AM4904
