Kontron AM4904, Руководство пользователя

Страница: 76 / 135

Operating the Unit
58 AM4904 User Guide
www.kontron.com
3.3.21 SRIO Commands
The serial RapidIO commands provide access to the serial RapidIO switch fabric chips and related CM config-
uration options. They are not available on other variants.
Note that initial configuration of sRIO strappings is configured using the standard CM configuration file. For
information about sRIO default settings, see “Configuring sRIO” on page 64.
3.3.22 Clock Commands
The clocking commands provide access to the PLL and the clock driver
sensor show asserted Show all asserted sensors SDR
sensor show fru <FRU-ID> Show all sensors SDR located on specified FRU-ID
sensor show type {temperature | voltage |
current | fan | hotswap | analog | discrete}
Show all sensors SDR of specified type
sensor theshold set <ID> {lnr | lcr | lnc | unc
| ucr | unr} <VALUE>
Set threshold for specified SDR ID
Table 3-23: CLI sRIO Commands
Command Description
srio reg read <UNIT> <ADDR> Read register from sRIO switch through I2C
srio reg write <UNIT> <ADDR> <VALUE> Write register to sRIO switch through I2C
srio show status Show sRIO switch fabric port link status.
Table 3-24: CLI Clock Commands
Command Description
clock disable <clk1 | clk2> <line0-11>
Disable all clock driver and receiver for specified
device
clock connect output <PLL-LINE> <clk | clk2> <line0-11>
Connnect a PLL signal via PLD mux to clock line on
the edge connector
clock connect input <PLL-LINE> {<clk2> <line0..11> | <clk1 | clk3>
update | <front> | <none>}
Connnect a clock line via PLD mux to a PLL refer-
ence input
clock pll config set <PARAMETER> <VALUE> Set PLL Configuration
clock pll config show Show PLL configuration
clock pll mode {normal | holdover | freerun | auto} [<DEVICE> |
front | none]
Set PLL running mode
clock reference expect <PLL-LINE> <frequency>
Set expected reference frequency for clock e-key-
ing
clock reference show Show PLL reference information
clock status show Show Clock status information
clock synth show Show synthesizer settings
Table 3-22: CLI Sensor Commands (Continued)
Command Description