Kontron AM4011, Руководство пользователя

Страница: 63 / 104

AM4011 Installation
ID 1022-1626, Rev. 1.0 Page 3 - 5
P R E L I M I N A R Y
3.3 Hot Swap Procedures
The AM4011 is designed for hot swap operation. Hot swapping allows the coordinated insertion
and extraction of modules without disrupting other operational elements within the system.
The procedures contained in this section are also applicable for “non-operating systems” with
the exception of indications and functions which require power to be applied.
3.3.1 Hot Swap Insertion
To insert the AMC module proceed as follows:
1. Ensure that the safety requirements indicated section 3.1 are observed.
2. Ensure that the module is properly configured for operation in accordance with the appli-
cation requirements before installation. For information regarding the configuration of the
AM4011 refer to Chapter 4.
3. Ensure that the module handle is in the “Unlocked” position.
4. Using the front panel as a grip, carefully insert the module into the slot designated by the
application requirements until the it makes contact with the carrier/backplane connector.
5. Apply pressure to the front panel until the module is properly seated in the carrier/back-
plane connector. This may require a considerable amount of force. Apply pressure only
to the front panel, not the module handle. During seating in the connector, there is a no-
ticeable “snapping” of the board into the connector. When the board is seated it should
be flush with the carrier or system front panel.
In the case of a running system, the following occurs:
• The BLUE HS LED turns on.
When the module is seated, the module management power is applied and the BLUE
HS LED turns on. (No payload power is applied at this time).
6. Connect all external interfacing cables to the module as required and ensure that they
are properly secured.
7. Push the module handle in the “Locked” position.
When the module handle is in the “Locked” position, the module is locked and the hot
swap switch is actuated.
Warning!
Failure to comply with the instruction above may cause damage to the
board or result in improper system operation.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the AM4011 nor other system boards are physically damaged by
the application of these procedures.