Könner & Söhnen KS 18-1DE-G, Инструкция по эксплуатации

Страница: 14 / 23

koenner-soehnen.com | 13
MANUAL MODE MANUAL MODE
1. Click
to start the engine. LED indicator that lights up next to the button indicates the selected
control mode.
6. Devices to the power plant must be connected one after another from the device with the maximum
power to the device with the minimum power, the total power of the connected devices must not exceed
the rated power of the power plant.
7. After receiving a stop signal, the station will stop and go into standby mode.
2. Allow the power plant to run without load for 5 minutes in the warm season and 10 minutes in the cold
season. This will ensure reliable and trouble-free operation of the station.
3. Controller performs diagnostics of power plant systems operation. If any malfunction is detected, the
controller will notify about the detected problem.
4. You can use the power plant if the controller does not detect any deviations within three minutes and
notifies about the detected problem.
5. Devices to the power plant must be connected one after another from the device with the maximum
power to the device with the minimum power, the total power of the connected devices must not exceed
the rated power of the power plant.
If the engine does not start after three or four attempts,
it may mean that the fuel tank is running out of fuel.
Check the fuel level in the tank according to the values
on the indicator.
IMPORTANT!
USING OF THREE-PHASE POWER PLANT MODEL: USING OF THREE-PHASE POWER PLANT MODEL:
The load of a three-phase diesel power plant must be distributed over all three phases, and the load on
all phases must be balanced.
TO STOP THE ENGINE, PROCEED AS FOLLOWS: TO STOP THE ENGINE, PROCEED AS FOLLOWS:
1. Turn off all devices connected to the power plant.
2. Allow the power plant to run for 3 minutes without load to allow the alternator to cool down.
3.Press the red STOP button on the IR controller
to stop the power plant in manual/automatic mode.
4. For immediate power plant shutdown in manual / automatic mode. Click again.
It is forbidden to load the power plant above the max.
power!
WARNING!
Failure to follow these instructions may lead to damage
of the rotor and stator windings, the AVR unit.
IMPORTANT!
If the power plant circuit breaker is triggered as a re-
sult of overloading - reduce the load. Re-switching of the
power plant is possible in 5 minutes after shutdown.
IMPORTANT!
On the housing near the control panel there is an emer-
gency motor switch (fig. 1). It should be used only in case
of an emergency.
IMPORTANT!
Disconnect all devices before stopping the power plant!
Do not stop the power plant if there are connected devic-
es. This can disable the power plant!
WARNING!