Konig SEC-CAM901, Руководство по эксплуатации

Страница: 11 / 31

SPEED DOME CAMERA
OPERATION INSTRUCTION
Speed dome can be driven through combination of hot keys on a keyboard controller. It can also be driven
through OSD menu. OSD menu can be activated by preset #95 call or double calling preset 1 (call twice within 5
seconds). Preset calling can be done through a keyboard controller or any other device (e.g. a computer ) that
can send proper command to the speed dome.
OSD menu operations are specified as follow:
PREHEATING SCREEN
When power on the dome and system temperature is
under -15C/5F following screen shows up:
Outer Temp :-030C/-022F
System Temp: -020C/-004F
Fan Speed :6480rpm
System Under
-15C/5
F
System Heating Up
Please Wait……
System heats up till the system temperature is above
-15C/5F. System starts to boot up after heating up
finishes.
< Outer Temp >
Environment temperature XXC/XXF C
Celsius F Fahrenheit
< System Tem >
System inner temperature
< Fan Speed >
The rotating speed of fan.
BOOT-UP SCREEN
When power on or restart the dome, the boot up
information will display on screen and then the dome
will conduct self-testing. “System booting up…” will
show on the screen until “boot-up success” shows up.
The whole boot up process lasts about 40 seconds.
This screen display disappears once the dome receives
any effective command.
Protocol : Ernitec
Baud Rate : 4800BPS
Camera ID : 001
Camera S/N : 8888888888
Model : -------------
Version : 1.20
Outer Temp :022C/071F
System Tem:027C/080F
Fan Speed :6480rpm
Booting Up… …
P t l
Dome control protocol.
<Baud Rate>
Dome control baud rate
<Camera ID>
The dome ID address set by dip-switch or
keyboard. (See APPENDX I)
<Camera S/N>
Camera serial number
<Model>
Speed dome model number.
<Version>
Hardware and software version
Protocol : Ernitec
Baud Rate : 4800BPS
Camera ID : 001
Camera S/N : 8888888888
Model : -------------
Version : 1.20
Outer Temp :022C/071F
System Tem:027C/080F
Fan Speed :6480rpm
Bootup Success
ACCESSING MAIN MENU
Display the dome’s main menu on your monitor
by calling preset 95 or calling preset 1 twice
within 5 seconds.
Note: For third party keyboard controller please
read manuals. As command to a preset may not
be the same among different manufacturers.
In case password protection is in effect, user
needs to input the correct 6-bit password to
enter the OSD menu. (Default password is
123456).
To enter password, move the joystick up or
down to select number (0-9), move the joystick
left or right to choose password digit. If the
input password is wrong, the password input
window will disappear.