Konig & Meyer 24615, Перевод оригинальной инструкции по эксплуатации

Страница: 23 / 27

Troubleshooting
Fault list
Maintenance
General
u
Regularly remove dust and dirt from the stand.
u
Regularly check the stand for damage.
u
Replace worn end caps as necessary.
If further defects should occur, please send the stand to the manufacturer for repair.
Spare parts
Disposal
Disposal of the stand including all attachments is subject to the local disposal regulations and the
environmental protection laws in the country of use.
Fault Remedy
Stand wobbles Extend legs to a maximum and tighten the
clamping screws.
Stand tube wobbles or moves under load Check whether the release button is pressed.
Tighten the clamping screws.
Height adjustment sluggish Check whether the clamping screw of the
crankcase is loose.
The stand cannot be cranked down Check whether the clamping screw of the
crankcase is loose.
Keep the release button permanently pressed
whilst cranking.
Naming Order no.
Clamping screw M8 x 16 mm 01-82-763-55
Clamping screw M8 x 21 mm 01-82-783-55
End cap 01-84-935-55
Hand crank 3-00-000-016
Hexagon screw M10 x 40 mm 03-01-760-25
Washer 01-36-320-55
23